How To Remove Motorcycle Rear Wheel Bearings

As anyone who owns a motorcycle knows, keeping it in good repair is essential for safety and longevity. One important maintenance task that can often be overlooked is the removal and replacement of rear wheel bearings, which can be complicated and tedious. The following guide will provide step-by-step instructions on how to safely and effectively remove the rear wheel bearings from your motorcycle.

First, you will need to gather the necessary tools: a torque wrench, a bearing puller, and a hammer. You will also need to get access to the rear wheel, so you may need to loosen or remove other components such as the axle nut, chain guard, and/or axle offset spacer. Once these items have been removed, you should be able to access the bearing.

The next step is to use the bearing puller to remove the bearing from its mounting hole. Start by placing the arms of the puller onto either side of the bearing. Then, using the torque wrench, slowly tighten the puller until the bearing pops out. If the bearing is stubborn and does not come out easily, you may need to use a hammer to lightly tap the puller free.

Once the bearing is removed, you will need to clean the area inside the mounting hole and inspect it for signs of wear or damage. If any damage is found, the wheel should be replaced. After cleaning and inspecting, the new bearing can be inserted and secured in place with the bearing puller and torque wrench.

By following this guide, you can easily remove the rear wheel bearings from your motorcycle and replace them with a new set. This important maintenance task is necessary to keep your bike running properly and prolong its lifespan. With a few simple steps and the right tools, you can quickly and safely complete this job yourself.

How To Replace Wheel Bearings On Your Motosport